Instructions for using the cable pay-off stand. The shaft bar of the cable pay-off stand passes through the center hole of the cable reel. Place the hydraulic pay-off racks on both sides of the cable reel respectively. Adjust the height of the inner tube so that the tile frame is close to the shaft bar, and then use Cable pay-off frame The horizontal pin on the side of the pay-off frame penetrates into the hole of the inner tube at a suitable height. Tighten the oil plug under the jack, and use the pressure rod to press the jack to lift the wire drum away from the ground and place the cable.
Notes
The hydraulic cable pay-off stand must be close to the wire reel to prevent the shaft from bending. The hydraulic cable pay-off stand must be used on a stable ground, otherwise it will easily tip over.
Ladder cable pay-off stand, commonly known as cable pay-off bracket, is used to place cable trays and spread wires or cables overhead. It adopts hydraulic device and has small wheels on the feet, which is easy to move, easy to operate and easy to use. Ladder cable The horizontal bar of the pay-off frame is made of drilled cable pay-off frame rod material and will not bend. Specifications are divided into tons, tons, tons and tons.
Manufacturer contact number
News